#Hp mediasmart server ex470 3.0 update update
#Hp mediasmart server ex470 3.0 update upgrade
#Hp mediasmart server ex470 3.0 update free

Then you can easily remove the card from the case without difficulty. To remove the card from the case, slide the card up gently until the metal guides line up with the slots in the card itself. ItвЂ™s attached to the drive cage on four metal guides, two along each side edge.

#Hp mediasmart server ex470 3.0 update free

If you gently lift the card just a little in this way, it should lift free from the motherboard. The easiest way to do this is to reach inside the drive bays, then stick one or two fingers through one or two of the holes in that circuit board. You must lift this card up to undock it from the motherboard.

#Hp mediasmart server ex470 3.0 update upgrade

These optional updates are available to purchase for owners of our EX470/475/485/487 products who want to upgrade their servers to the latest 3.0 software that is shipping on.

#Hp mediasmart server ex470 3.0 update update

ItвЂ™s where each of the four internal SATA drives that the HP MediaSmart Servers accommodate plug in for motherboard access. HP MediaSmart Server 3.0 Software Update Availability The 3.0 software update DVD will be available to order beginning later this week, with shipments beginning next week. The green circuit card with an edge that is flush with the back opening in the case is a modular four-port SATA backplane that plugs into a special socket in the motherboard below. Step 4: Remove the Backplane from the Motherboard Swing both 90В° so that the handles are parallel to the sides of the case. From the front, the left-hand side latch swings left, and the right-hand side latch swings right. You may have to gently rock the 10-pin connector side to side to get it to let go.ДЇinally, youвЂ™ll want to swing the two latches down that lock the SATA card into place. The fan cables should slide right out (I marked mine L and R for left and right to make sure they went back into the right pin blocks). ItвЂ™s pretty safe to grab these cables by the connector or the wires just as they enter the connector and gently remove them from their mounts.

YouвЂ™ll want to gently remove the fan cables and the 10-pin connector from their mountings. Step 3: Loosen the Backplane Cables and Unlock the LatchesДЄs shown in the initial photos, a pair of (four-pin) fan cables in black, yellow, and blue and a 10-pin control cable connector plug into the top of the SATA backplane at the rear of the enclosure. When you finish, the bottom (system) drive should be on top of the stack.

As you remove each tray from the top town, stack it on top of the preceding trays (I rotate mine 90В° between layers, to make the stack more stable). I worried about the plastic trays being too flimsy, and got into this habit pretty quickly. Once you get the first tray out, if you encounter resistance in removing other trays, you can reach inside the enclosure and grab the rear edge of the drive for a gentle pull forward. Lift the latch at the center of the tray, then pull gently on the A-arm at the bottom of the tray. When you take the drive trays out of the unit, remove the top one first. The HP MediaSmart Server cares a great deal about physical drive arrangement and order. Stack drives and trays carefully as you go